€0,00
Ajouter au panier

24er Workhorse Damast

24er Workhorse Damast
24er Workhorse Damast
24er Workhorse Damast
24er Workhorse Damast
24er Workhorse Damast
24er Workhorse Damast
24er Workhorse Damast
24er Workhorse Damast
24er Workhorse Damast
24er Workhorse Damast
€0,00
* Taxes incluses Sans les Frais d'expédition

Ein 24er Workhorse mit einer Schneide aus 1.2562 und einem Griff aus stabilisiertem Maser Nussbaum. Lire plus..

The blade of this knife has a edge made of 1.2562. With its 66hrc working hardness and the very high content of tungsten special carbides, the steel has enormous resistance to abrasive wear. In particular, the high hardness and wear resistance combined with good toughness (for a steel of this hardness) characterize this steel. This is particularly noticeable in everyday life because a blade made of 1.2562 keeps its sharpness significantly longer than blades made of softer and less wear-resistant steels.

This knife has a complex workhorse geometry. The blade tapers significantly towards the tip, but remains a bit more powerful overall and has a higher weight. The first 15mm behind the edge are hardly rounded. In combination with the thin edge, this blade is a very good performer despite the larger blade thickness. This is supported by the higher weight of the blade. The blade has a "Walkschliff", the convexity of the blade decreases towards the tip

After the last fire weld at 970 degrees, the initial package with a thickness of about 60mm was forged down within one heat with a forging start temperature of 900 degrees to about 15mm and then immediately cooled to below 720 degrees. The subsequent form forging then took place at a maximum of 810 degrees. After each heat, the blank was cooled to below 720 degrees. This process creates a very fine-grained matrix as well as very small and finely divided carbides.

Schneidenlänge/lenght of edge:

239mm

Max. Klingenhöhe/max. height of the blade:

50mm

Klingenstärke am Rücken/thickness of the blade:

 
Angel/tang:

6,0mm

Kehl/choil:

5,7mm

Mitte/middle:

3,4mm

20mm vor der Spitze/20mm before the tip:

1,2mm

Grifflänge/lenght of the handle:

117mm

Gewicht/weight:

269g

Schwerpunkt/balancepoint:

38mm vor dem Griff/before the handle

Geometrie/geometry:

Workhorse

Schneidenstahl/core steel:

1.2562, C=1,45%, W= 3,0%, Cr= 0,3%, V= 0,2%, ca. 66hrc

Zwischenlage/intermediate layer:

Reinnickel/nickel

Seitenlagen/clad:

Damaststahl aus

Damascus steel made of:

1.2842, C=1,0%, Mn=2,0%, Cr=0,4%

1.2767, C=0,45%, Ni=4,0%, Cr=1,5%

Griffmaterial/material of the handle:

Stabilisierter Maser Nussbaum, schwarzes Fiber, Bronze/stabilized walnut burl, black fiber, bronze

Griffform/ shape of the handle:

Westlich/western

Veuillez accepter les cookies afin de rendre ce site plus fonctionnel. D'accord? Oui Non En savoir plus sur les témoins (cookies) »